HVAC & Sheet Metal Services in Windsor
One contractor for the whole job. Heating, cooling, gas and ventilation installs for homes, and custom galvanized steel fabrication for other contractors, all from our own shop in Windsor.
Equipment and the Metal
Most HVAC jobs touch more than one trade. A new furnace needs gas, venting and ductwork. A tankless water heater often needs a bigger gas line. A central AC needs a coil that fits the furnace and ducts that carry the air. When each part goes to a different company, the gaps between them are where problems start.
Mike Deez Metal Contractors does the whole job. MDMC is TSSA registered for the gas work, bonded and insured, and holds an A+ rating with the BBB. The shop at 1429 Pelissier Street builds plenums, transitions and trunk line from galvanized steel on its own brake, so the metal around your equipment is made to fit instead of forced together. Mike has more than 30 years in sheet metal and HVAC.
The same shop builds custom fittings for other contractors. If you are a homeowner, that means the people installing your system build ductwork for the trade every week.
Heating, Cooling and Gas
Furnace Replacement
Gas furnaces, unit heaters and wall heaters. Old unit removed and customized ductwork built to fit the new one.
Furnace Replacement → 02Tankless & Storage Water Heaters
Tankless with or without a recirculation pump, and 40, 50 and 60 gallon tanks in high efficiency, standard and direct vent.
Water Heaters → 03Gas Lines & Venting
Whole house gas systems, lines to any residential appliance, zone control and all kinds of ventilation.
Gas Lines & Venting → 04Heat Pumps / Mini Splits
Any and all kinds. Whole house heat pumps on your ducts, and ductless mini splits for single rooms or several.
Heat Pumps → 05Central ACs
Central air and ductless systems sized for humid Windsor summers, with the coil and sheet metal to match.
Central ACs → 06HRV / ERV & Air Quality
Simplified, partially dedicated or fully dedicated fresh air systems, plus ultra UV air purification.
HRV / ERV → 07Repairs & Maintenance
Service calls when something stops working, and preventative maintenance contracts so it stops less often.
Repairs →Custom Galvanized Fabrication
Custom Metal Work
Plenums, Y branches, transitions and offsets, trunk line, takeoffs and elbows, combination unit and rooftop transitions, and one off custom pieces. Send a sketch, drawing or photo with dimensions. Pickup or delivery.
Custom Metal Work →Contractors, HVAC shops and builders send us measurements and we build the piece in our Windsor shop. It is the same shop that builds the ductwork for our own installs.
How We Work
Call
Call or send the form and tell us what you need.
Visit
We come and look at the space, the equipment and what has to connect to it.
Quote
You get a written quote before any work starts.
Install
The work is done, tested and checked.
Cleanup
Old equipment hauled away and the work area left clean.
General Questions
Are you licensed for gas work?
Yes. MDMC is a TSSA registered contractor. We are also bonded and insured, with an A+ rating from the BBB.
Do you give free quotes?
Yes. Call or send the form and we set up a visit and a written quote.
Do you work outside Windsor?
Yes. We work across Essex County, including Tecumseh, LaSalle, Lakeshore, Amherstburg, Essex, Kingsville and Leamington.
Can you do the ductwork as well as the equipment?
Yes. We build ductwork in our own sheet metal shop, so it is part of the same job.
Not Sure Which Service You Need?
Call and tell us what is going on. We will point you the right way.